My H quad , with canopy design build and fly

by Jevohn | July 14, 2014 | (0) Posted in Projects

In my last article I showed how I design a canopy for the H quad by flite test.

This article I will show you the installation of electronics and flight of my quad copter.

The stuff to get my quad flying.

Soldering of connectrors to motors

Connectors are soldered to the four motors

The Escs for the quad , Turnigy 30 amp Escs

Soldering connectors to escs

Mounting Motors to Quad with cable ties

Motors and esc installed and connected to power distributor

Escs zip tied

Landing gear

Completed installing the electronics and landing gears. Now propellars

completed quad

The Quad landing gears had to be reinforced with dowels to make them sturdy

Also the frame was stregnthened with T brackets to reduce twisting

Here is a video of my completed quadcopter flying

EZ Air on October 9, 2014

how much did this build cost?

Log In to reply

Jevohn on October 10, 2014

The build cost me around a lil more than $200 which includes electronics and cost of frame materials.
Log In to reply

JACKFIRE on October 10, 2014

You should say that your design is based in the Curtis Youngblood Stingray 500
Log In to reply

Jevohn on October 10, 2014

yes is should, I did mentioned that in my previous article.
Log In to reply

(68)

Log-In