I used Alumiweld brazing rods to put together this inexpensive durable H-quad. I wanted to see if it was practical to use the Alumiweld product to put together an H-Quad which will eventually be an fpv ship. I was very happy with the versatility of the Alumiweld product and how easy it was to use.
Cad drawing of H-quad in pdf format the picture below is unreadable. Download the pdf to see the demensions.
You can check out this video where go into detail on how to use Alumivweld. http://youtu.be/aWKYROX46Yk
Website for Alumiweld http://www.alumiweld.com/
Parts List
Turnigy TY-P1 25Amp HEXFET Brushless Speed Controller (simon k flashed)
NTM Prop Drive 28-26 1000KV / 315W (short shaft version)
Hobbyking KK2.0 Multi-rotor LCD Flight Control Board (flashed with ver 1.5 firmware)
FrSky V8FR-II 2.4Ghz 8CH Receiver (HV)
Turnigy 9XR Transmitter Mode 2 (No Module)
FrSky DJT 2.4Ghz Combo Pack for JR w/ Telemetry Module & V8FR-II RX
Turnigy 5000mAh 3S 35C Lipo Pack
Gemfan 9x4.7 nylon carbon Propellers
0 comments