Quick cheap and easy camera mount that reduces jelly view in your recorded footage.
Using only one plastic ID card, 2 cable ties and 2 small rubber bands.
Step by step instructions, real time video and test videos below.
What you will need -
ID card
4mm x 200mm cable ties x 2
small rubber bands x 2
Office hole punch, scissors, wire cutters, marker pen
Cut the ID card in half
Punch 4 holes in each half
Wrap 2 rubber bands around one half, towards the middle from the holes
Thread cable ties through the holes like this, making sure the join ends up between the holes and the two cards.
Start from the middle, pass the cable tie up through a hole, out and around the card edges.
Clip off the tails and it's all done. Mount the camera on the anti-vibe mount. Attach the mount to your aircraft using velcro, tape, glue or however you want and go record some smooth jelly free video.
Full assembly video in real time
Mount vs no-mount comparison on my Depron Spectre
0 comments