Hi Guys,
This is the first time I have posted something on Flite Test. I'm currently putting together a ground station that I can use in conjunction with a few of my RC planes and quad/hexcopters.
This is my first attempt at putting something together which has a little bit to go to complete the build.
A list of things I have used:
Outside
Inside
All wiring plugs in to the HobbyKing Quadcopter Power Distribution board.
Front View
Back View
Side View
Close Up
Close Up 2
Close Up 3
Unfortunately the timber has bowed from all the moisture in the air (it has been raining here for about four days in country New South Wales - Australia). Also, sorry about the bad lighting in the photos.
I still have some things to do that will finish the project off. This includes buying another video receiver for a second antenna, tidying cords, finishing the paint and I want to have a dual battery switch for two batteries (I'm running all this gear plus a laptop off the batteries).
I'm going to change the antenna tracking system to the Arduino Ardupilot setup because I'm using Ardupilot in my multicopters and I really like the system. As you're probably aware, its leaps and bounds ahead of the Eagletree system.
I hope you found this interesting.
0 comments