The problem with flying RC is storing ALL your planes and other models.
As I really like the FT Swappable thing this came to be a problem when I was re-doing my sons room and needed a way to store his three models (Nutball, Flyer, Delta) so I turned to my own little factory, the 3D printer.
The idea was to make something like a clothespin and so the FT Simpe Clip was borne.
The 3D file can be found on Thingivers (http://www.thingiverse.com/thing:1254575)
Use a short but strong rubber band as you need the force to hold on to the pins of the plane.
To hang it under the shelf I used the "Plane Hanger" (http://www.thingiverse.com/thing:39779) printed at 67%
0 comments