Get on your Race Face!

Race Time!

It is post time once again folks,lets get it on!

Back at Croutch Memorial Quad Track.
Just over a quarter mile. Lots of hazards. 
RedCloud has the Superman view with his Hybrid Minion.
I am flying the Hex. 
We are using the white gate for a Start/Finish

Hybrid Minion,
G-10 top and bottom main plates. Light weight 100% pure 3K Twill Weave Carbon Fiber arms. Mini H Quad

THE WASP
Pat G's New Mini Hex frame.
Full Carbon lower plate and arms. Yellow G10 top deck or full CF top!


Nicely engineered with a full carbon fiber lower deck and arms it is rigid and light. 323 mm at the widest and 725 grams AUW with a 2200mah 3s and FPV gear. Arms will fit a range of motors and will accommodate 6 inch props!

CF Wasp weighs just 185 grams!
Wasp with G-10 top plate weighs 206 grams.


Typical setup

2204 motor 2300kv for 3S, 1960kv for 4S
12A ESC
Naze32 flight controller or other 36x36mm FC
5" or 6" props

My set up as of today..
HIEE 1.5w TS3215 5.8G Video Tx

RunCam Sky camera 2.1mm wide lens

KVOSD

Fr Sky DR4 II 4ch telemetry receiver

RCX 1804 (2400KV) Micro Outrunners

RCX 10A ESC Brushless Motor Speed Controller (G Series / Programed for Multicopter - SimonK Firmware)

Minion frames and parts at these fine locations.

Canada
http://patsminihquad.com

http://www.greathobbies.com/index.php

http://www.hoverallrc.com

http://www.bcmultirotors.com

http://rotorgeeks.com/index.php?route...


U.S.A
http://diyquadcopter.com.

http://www.getfpv.com/