Callum. W
Instructions
Unroll the bulk iron-on material on a workbench.
Measure out three 1-by-1/2-inch strips of the material. Cut them out.
Turn the strips over to the glue side of the
material. The aircraft iron-on material has glue on one side that is heat
activated.
Overlay the three strips by 1/2-inch per strip,
making one large hinge. Turn on the heat gun. Apply heat to the strips so the
glue warms and then sets, securing the three together.
Push the hinge between the wing flap and the wing.
Keep the glue side up against the surface of the flap and wing and apply heat
to set the hinge to the airplane.
0 comments