Hi everyone,
This is a short introduction to my tricopter. Basically I designed the center frame plates of TurboCAD and had them cut out of 4mm thick acrylic ( waiting on my FP4 sheet) at a local sign shop on their 2-axis cutter. The arms, motor mounts and all mounting pieces for the arms are Tarot 16mm accessories. In all the frame cost about USD $50 to build here in Chengdu China.
Power and Flight control:
APM 2.6 w/ 6H GPS
1045 props
2217 - 950kv motors
Hobbywing 30A ESCs
Metal gear servo
3S 4200 mah
FPV equipment:
AEE S51 camera
5.8GHz 200mw Tx
cloverleaf antenna
11db patch Rx antenna
WFT09 2.4GHz Radio transmitter
Hope everyone likes it. .dwg
0 comments