This will show you how to make literally hundreds of control horns for just about ten bucks. What you will need...
- 1/16" plastic for sale sign, I got mine from ACE Hardware and it was just under $10.00.
- Metal ruler, ideally 1 1/4" wide
- Box cutter, or sharp scissors
- Small Exacto knife
- Sharpie marker
[broken image - invalid source]
[broken image - invalid source]
[broken image - invalid source]
Next, use the ruler and box cutter to cut the squares out, as many as you need, each square makes two control horns.
[broken image - invalid source]
[broken image - invalid source]
Mark 1/4" in from each corner, on opposite sides of the square, then draw a line to connect them diagonally. Next, draw a line from each mark, parallel with the edge of the square. The end result will be a "Z" shape, as shown below.
[broken image - invalid source]
[broken image - invalid source]
[broken image - invalid source]
[broken image - invalid source]
Draw a line though the center of the "Z", vertically, like below.
[broken image - invalid source]
Cut the bottom left, and upper right rectangle away from the square, as shown.
[broken image - invalid source]
[broken image - invalid source]
Then cut across the diagonal line. Use the small Exacto to "drill" out a small hole for the pushrod.
[broken image - invalid source]
I use the sharpie to color them black, then throw them on your scratchbuilt plane using hotglue.
[broken image - invalid source]
[broken image - invalid source]
Enjoy, hopefully that isn't too confusing, and please let me know what you think... Thanks!
0 comments