Mini PVC V-Tail Maiden

December 31, 2012|rcjoseb

Here's my new scratchbuild, a much smaller version of the PVC V-Tail. After some tuning of the HK KK2 board, it flies ok. Will have to test it further on day that is not so windy. All flying was done with self level off. I have a detailed view of the v-tail at the end of the flights.

Emax CF2822 motors
9x5 props
3mm prop adapters
Turnigh Plush 30A ESC
HK KK2.0 conroller with V1.5 firmware
3S 25C 3300mah LIPO
Mini power spider (power flower)
0.5" schedule 40 pvc pipe
0.5" schedule 40 pvc tee connectors
0.5" schedule 40 pvc 45 degree elbows
6-32 x 1.25" screws
6-32 nuts
Tupperware bowl
4" square carlon plate
lightweight plywood
scrap mouse pad
rubber bands and zipties
rubber grommets

All PID settings are the same. Pgain @ 60, I gain @ 30 and limits @ 75 using non flashed Turnigy Plush 30A ESCs.