In my last article I showed how I design a canopy for the H quad by flite test.
This article I will show you the installation of electronics and flight of my quad copter.
The stuff to get my quad flying.
Soldering of connectrors to motors
Connectors are soldered to the four motors
The Escs for the quad , Turnigy 30 amp Escs
Soldering connectors to escs
Mounting Motors to Quad with cable ties
Motors and esc installed and connected to power distributor
Escs zip tied
Landing gear
Completed installing the electronics and landing gears. Now propellars
completed quad
The Quad landing gears had to be reinforced with dowels to make them sturdy
Also the frame was stregnthened with T brackets to reduce twisting
Here is a video of my completed quadcopter flying
0 comments