Here is a few photos of my new quadcpoter. It was all 3d printed on a solidoodle second generation printer at .2mm layer hight. All of the electronics are salvaged from an old turnigy micro quad. flies well with the gopro on a three cell and really struggles with a two cell.
turnigy bullet proof plush 6 amp ESC 
turnigy 1811-2900 motors
the 3d printed arms are great at removing vibrations from the frame
flies with a KK2.0 board and spektrum reciever and transmitter
a 3d printed case for the gopro
Gopro sticky mount straight to the frame but has a lot of jello in the footage
Still need to make longer landing gear as it is hard to take off from the gopro and terrible for the gopro when I crash.
0 comments