In the third video in this hexacopter build series we are going to talk about programming and setting parameters for NAZA V2 flight controller, Futaba T14SG Transmitter, ESCs, as well as make last touches to make the copter ready for maiden flight.
We will also cover basic procedures in multi-rotor building like ESC throttle calibration, stick calibration, model setup, motor reversing etc.
WARNING:
Do not install propellers until you finish all of the steps shown in this video. Propellers should always be installed at the end!
Link to NAZA V2 Assistant Software:
http://www.dji.com/product/naza-m-v2/download
Hexacopter weight: 1.865 g
You need:
Foxtech Supreme Lite CF Propellers 12x5,5
Accessories:
4S Battery
3S Battery
Tools:
2.0 Hex Screwdriver
Threadlocker
Additional Information:
Video: Canon 600D/T3i - 18-55 mm Lens
Editing: FinalCut Pro X
Music: GarageBand
0 comments