Introducing the Ycopter 350 FPV Quadcopter.
www.ycopter.co.uk
After years of design and development I have produced my first frame which is available as a kit.
The Ycopter 350 is a mid sized quadcopter (350mm square), large enough to carry a GoPro in its protective case but small enough to allow agile flight.
The principal citeria for all of my designs is the most stable and smoothest 'prop free' video possible.
Smooth video is achieved by a full floating top plate which holds the battery, control board and camera gear, this is mounted by six vibration isolation rings to the lower frame. The electronic components are perfectly matched to ensure the quadcopter is stable and controllable at all power levels. The frame is light and rigid which allows the use of higher power set-ups.
Another key design consideration is its ability to be easily repaired from locally sourced materials. The vibration rings and motor arms can be replaced by using locally sourced materials.
The balance can be easily adjusted by moving the flight battery forwards or backwards which allows a wide range of battery sizes and payloads. The battery is very easy to access and change between flights.
The top plate is pre drilled for the common hole spacing of boards such as the KK2.0, Naze32 and CC3D.
The ESCs are protected in the inner frame which reduces external wiring giving a very clean look.
www.ycopter.co.uk
0 comments