There are so many requests about my flying wing plan which optimize one sheet foam board and only require some simple straight cutting and bevel. I have share the plan v1 and v3 (my v2 is not success yet) on flitetest few months ago. I found that the v3 is the most popular since it get more feedback than the v1, but personally I prefer v1 for daily use, because the v3 actually prepared for the high speed application.
Ok let me summarize the different of both version
===============================================================================
V1
- Require more technique
- More wingspan (41”)
- Less swept
- More glue required
- Little bit hard to trim (on maiden)
- Suitable for slow-medium speed
- Here is the article of v1 and here is the CG v1 documentation (size is in mm)
- Here the action of v1
===============================================================================
V3
- Less technique required
- Less wing span (36”)
- More swept
- Less glue required
- Slightly easier to trim
- Suitable for high speed or extreme one
- Here is the article of v3 and here is the CG v3 documentation (size is in mm)
- Here the action of v3
===============================================================================
I hope this article is helpful
0 comments