Fiberglass supply from computer parts

A few days ago I broke two motor mounts on my x525. I needed a quick fix so I can fly again quickly. I went to local shop and they had only 1mm aluminium stripes witch are realy thin for motor mounts. My old GPU that i used for my battery mount still lying on my table. PCB from it is same thicknes as original mounts, but is much more stronger.

 Video tutorial:

First of all i brutaly desoldered parts from PCB

Than i clean the surface with sand paper

  
Than i traced original mounts

 
Nex step was to cult them out and drill the holes

.
And there you have it, super stylish motor mounts. They are same thicknes and much more stronger.

 I replaced only broken ones, but i will replace all in the future.

Thanks, i hope you liked it and dont forget to rate this artile.